Main content
Ship’s propellers for AIDAstella
Efficient design saves fuel
Rostock, 21. January 2013
With 5 blades and a diameter of 5.2 meters – one propeller alone weights 12,800 kilograms. Today, the final work was completed on the two brass propellers for the latest club ship, AIDAstella, at the Meyer Werft shipyard in Papenburg.
The 35 meter long drive shafts are operated by two electric motors. Located at the end of the shafts are the two propellers, which enable AIDAstella to pick up speed. The design of the propellers has a crucial influence on how much energy is needed to propel the ship. The use of flow-optimized propellers and rudders has enabled AIDA Cruises to lower fuel consumption even further. The rudder blades are twisted asymmetrically at the level of the propeller hub. This design produces a sail effect, which gives the ship additional propulsion.
The ship’s propellers were produced at the propeller plants in Waren (Müritz) in the Federal State of Mecklenburg-Vorpommern and were designed especially for AIDAstella. Producing them is a real art, combining high-tech with traditional craft.
AIDAstella’s propellers will turn through the water for the first time on January 25, 2013 when the ship is undocked from Dockyard 1 and moved to the fitting-out wharf.
Further information on AIDAstella can be found at www.aida.de/aidastella.
Rostock, January 21, 2013
30. April 2020
Video message from Captain Boris Becker: “Thank you, Barbados”
In an emotional video message Boris Becker, captain on board AIDAperla, thanks for the stay in Barbados. The ship has been lying in the roads at Barbados/Bridgetown for over a month and will now set sail. The passage leads directly to Europe in order to bring the rest of the ... [more]
08. April 2020
AIDA Cruises extends pause of its cruise operation until 31 May and offers bonus on travel credit
The worldwide spreading of the coronavirus presently confronts economies and companies with unprecedented challenges. The global tourist traffic has ground to a halt. Due to the current entry requirements in our destinations, the tourist traffic is not expected to normalize ... [more]
24. February 2020
AIDAcosma: 140-meter-long LNG engine room unit to be transferred from Rostock-Warnemünde to Papenburg
Early this morning (February 24, 2020), it was “Cast off!” at the Neptun Werft shipyard in Rostock-Warnemünde for the 140-meter-long, 42-meter-wide, and four-deck-high floating engine room unit for AIDAcosma. The construction module of AIDA Cruises’ second cruise ship to be ... [more]